In plastering engineering, the construction process of plastering mortar on the surface of the base material, which has the functions of protecting the base and increasing the aesthetics and providing special functions for the building, is called plastering engineering. The plastering project has two main functions: one is to protect the wall from the erosion of wind, rain and snow, to increase the ability of moisture-proof, weatherproof and heat insulation of the wall, to improve the durability and thermal performance of the wall; the other is to beautify the function and to improve the indoor sanitation conditions.

　　凈化空氣初烘，美化環境涡真，提高居住舒適度。抹灰工程通常分一般抹灰和裝飾抹灰兩大類抹灰砂漿的種類根據抹灰砂漿功能的不同貌授，抹灰砂漿分為一般抹灰砂漿吟因、裝飾抹灰砂漿和特種抹灰砂漿。根據生產方式的不同势嫁，分為現場拌制抹灰砂漿和預拌抹灰砂漿厂跋。

　　Purify the air, beautify the environment and improve living comfort. Plastering engineering is usually divided into general plastering and decorative plastering. According to the different functions of plastering mortar, plastering mortar can be divided into general plastering mortar, decorative plastering mortar and special plastering mortar. According to the different production methods, it can be divided into field mixing plastering mortar and ready mixing plastering mortar.

　　抹灰砂漿的組成材料膠凝材料，常用的膠凝材料有水泥谨寂、石灰猫降、聚合物、建筑石膏等脆携。水泥淫沧，通用硅酸鹽水泥均可以用來配制砂漿豌魏，水泥品種的選擇與砂漿的用途有關。通常對抹灰砂漿的強度要求并不很高院抛，一般采用中等強度等級的水泥就能夠滿足要求.抹灰砂漿強度不宜超過基體材料強度兩個強度等級.粘貼飾面磚的內外墻唉私，中層抹灰砂漿的強度不低于M15，且優先選用水泥抹灰砂漿染突。堵塞門窗口邊縫及腳手眼捻爷、孔洞堵縫，窗臺份企、陽臺抹面宜采用M15, M2D水泥砂漿也榄，水泥砂漿采用的水泥強度等級不宜大于32. 5級;水泥混合砂漿采用的水泥強度等級不宜大于42. 5級。如果水泥強度等級過高司志，會產生收縮裂縫甜紫，可適當摻人摻加料避免裂縫的產牛。

　　Cementitious materials are the components of plastering mortar. The commonly used cementitious materials are cement, lime, polymer, building gypsum and so on. Cement and general Portland cement can be used to prepare mortar. The choice of cement varieties is related to the use of mortar. Usually the strength of plastering mortar is not very high, generally using medium-strength grade cement can meet the requirements. The strength of plastering mortar should not exceed two strength grades of matrix material strength. The strength of plastering mortar is not lower than M15 when plastering interior and exterior walls of facing bricks, and the strength of middle plastering mortar is preferred to use cement plastering mortar. The M15 and M2D cement mortar should be used for window and balcony plastering. The cement strength grade used for cement mortar should not be greater than 32.5 grade, and the cement strength grade used for cement mixed mortar should not be greater than 42.5 grade. If the strength grade of cement is too high, shrinkage cracks will occur, and the cattle with cracks can be avoided by adding appropriate additives.

　　聚合物的種類和滲至在很大程度上決定了聚合物水泥砂漿的性能骂远。改變了傳統砂漿的技術經濟性能囚霸。目前已開發出品種繁多、性能優異的各類聚合物砂漿激才。建筑石膏建筑石膏也稱二水石膏拓型，將天然二水石膏在件下加熱可得建筑石青。建筑石膏與其他膠凝材料相比有以下特性:凝結硬化快瘸恼。

　　The types and penetration of polymers largely determine the properties of polymer cement mortar. The technical and economic performance of traditional mortar has been changed. At present, various kinds of polymer mortars with various varieties and excellent properties have been developed. Building gypsum and building gypsum are also called dihydrate gypsum. Building gypsum can be obtained by heating natural dihydrate gypsum under parts. Compared with other cementitious materials, building gypsum has the following characteristics: fast setting and hardening.

　　建筑石膏在加水拌合后吨述，漿體在幾分鐘內便開始失去可塑性.3min內完全失去可塑性而產生強度.凝結硬化時體積微型脹。石膏漿體在凝結硬化初期會產生微膨脹.這一性質使石膏制品的表面光滑钞脂、細膩阅王、尺寸梢確、形體飽滿狡煎、裝飾性好培扳。建筑裝飾工程中很多裝飾飾品、裝飾線條都利用這一特性瞧纹，廣泛使用建筑石膏硫薇，孔隙率大與體積密度小。

　　After mixing with water, the plasticity of the slurry begins to lose within a few minutes. Within three minutes, the plasticity completely loses and the strength is produced. The volume of the slurry expands minimally when it solidifies. The slight expansion of gypsum paste occurs in the early stage of setting and hardening, which makes the surface of gypsum products smooth, delicate, accurate in size, full in shape and good in decoration. Many decorative ornaments and decorative lines in architectural decoration engineering take advantage of this characteristic, and widely use building gypsum, which has large porosity and small volume density.

　　建筑石膏在拌合水化時澳券。在建筑石膏制品內部形成大橄的毛細孔隙但治，所以導熱系數小，吸聲性較好乎渊，屬于輕質保溫材料习诬。具有一定的調溫與調濕性能。由于石膏制品內部大量毛細孔隙對空氣中的水蒸氣具有較強的吸附能力崩蚀，所以對室內的空氣濕度有一定的調節作用零短，防火性好壤趴，耐水性、抗?jié)B性瑞侮、抗凍性差的圆。細骨料配制砂漿的細骨料常用的是禾然砂。砂應符合混凝土用砂的技術性能要求半火。由于砂漿層較薄.砂的大粒徑應有所限制越妈，理論上不應超過砂漿層厚度的，宜選用中砂钮糖，大粒徑不大于為宜梅掠。砂的粗細程度對砂漿的水泥用量、和易性藐鹤、強度及收縮等影響很大瓤檐。

　　When building gypsum is mixed and hydrated. The capillary pore of olive is formed in the interior of building gypsum products, so the thermal conductivity is small and the sound absorption is good. It belongs to the light thermal insulation material. It has certain performance of temperature and humidity regulation. Because a large number of capillary pores in gypsum products have strong adsorption capacity for water vapor in the air, it has a certain regulating effect on indoor air humidity, good fire resistance, poor water resistance, impermeability and frost resistance. The most commonly used fine aggregate for preparing mortar from fine aggregate is gramineous sand. Sand should meet the technical performance requirements of concrete sand. Because the mortar layer is thinner, the maximum particle size of sand should be limited. In theory, it should not exceed the thickness of the mortar layer. Medium sand should be selected, and the maximum particle size should not exceed. The coarseness of sand has a great influence on the cement content, workability, strength and shrinkage of mortar.