It is better to use a kind of putty powder, because the compressive strength of the two putty powders is different, the compressive strength and water content of the putty powder are different, and the surface layer with the same matching property of the whole putty powder will be stronger.

　　外墻膩子粉可以用兒童粉貼墻紙嗎?

　　Can children's putty be used to paste wallpaper on the exterior wall?

　　配合墻紙狰宗，建議使用內墻膩子粉牲羊。其他如批量樂寶2合一渠吮、批量樂寶麗家全面層膩子粉辉哥、快涂寶麗膩子粉恼布、OEM膩子粉等建議僅適用于墻面涂料系列產品。(由于non-moisture-resistant粘貼壁紙電影產品必須使用基地,基地電影稀釋劑后,鼓繼續來回滾油漆膩子粉層,大量的水會滲透膩子粉層,導致non-water-resistant膩子粉融化,不僅內墻膩子,所有其他non-water-resistant膩子粉會產生類似的條件)秕岛。如客戶已使用不防水膩子粉工闺，則在膩子粉表面涂上八紅星結構加固劑20%稀釋劑，然后涂上基膜瓣蛀，貼墻紙。

　　With wallpaper, it is recommended to use putty powder for interior wall. Other suggestions such as batch Le Bao 2-in-one, batch Le Bao Lijia full-scale putty powder, fast coating Bao Li putty powder, OEM putty powder are only applicable to wall coating series products. (since the film products of non-motion-resistant wallpaper must use the base, after the base film diluent, the drum continues to roll back the paint putty layer, a large amount of water will penetrate the putty layer, resulting in the melting of non water resistant putty, not only the interior wall putty, but all other non water resistant putty powder will produce similar conditions). If the customer has used the non waterproof putty powder, apply 20% diluent of eight red star structural reinforcement agent on the putty powder surface, then apply the base film and paste the wallpaper.

　　應用防水膩子粉杭恩，能長期分離進行拋光嗎?

　　Can waterproof putty powder be used for long-term separation and polishing?

　　耐水膩子粉與某水泥組件踢周、膩子粉后的抗壓強度比規范水膩子粉更強,并具有一定的耐磨性膩子粉抗壓強度和更徹底地改善混凝土凝固時,抗壓強度會越來越強萤考。因此,耐水膩子粉刮后進行,使越來越多的努力更加困難的時間打磨拋光,人們建議刮完忍受水膩子粉,2天內進行打磨拋光,所以工人不容易感覺打不動,還是放松!

　　The compressive strength of water-resistant putty powder, a cement component and putty powder is stronger than that of standard water putty powder, and has certain wear-resistant putty powder compressive strength and improves the concrete setting more thoroughly, the compressive strength will be stronger and stronger. Therefore, the water-resistant putty powder shall be polished after scraping, which makes more and more efforts more difficult. It is recommended to endure the water putty powder after scraping and polish within 2 days, so the workers are not easy to feel that they can't move or relax!

　　內墻膩子粉

　　Putty powder for interior wall

　　在膩子粉工程施工時，很輕易出現氣泡狀態黎撤，這要害與農村基層松散程度乒柳、含水量有直接關系。為了防止建筑工地泡沫狀況的產生侄灭，在農村基層解決方案中一定要注意哪些層次?

　　In putty powder construction, it is easy to appear bubble state, which is directly related to the loose degree and water content of rural grass-roots. In order to prevent the foam situation of construction site, which levels must be paid attention to in the rural grass-roots solutions?

　　項目施工前要保證農村基層足夠干燥彭铐、牢固，無油污等松散物質亏傅。如原裝農村基層認可的老粉摊谢、堵縫灰泥、紙面筋粉等必須全部清潔;兩次刮灰的時間間隔在一次刮灰前進行辨別醉装，一次刮土后進行一次刮土;老墻后清理干凈整潔辕芳、農村基礎水平孔隙度、寬松的原因,解決方案是清晰的寬松立場,刷涂結構整合代理一次,孔隙度時更多的是選擇膩子粉批刮薄批量添加填充孔隙度處理,如果干燥后引起泡沫,泡沫后沖力推土再次刮粗宵睦。另外记罚，墻面環境濕度太大，膩子也容易產生氣泡壳嚎，膩子粉砂漿稠度太低批量刮制也容易產生氣泡和收縮桐智，請注意油漆匠調拌膩子粉時粘度的調整。乳膠漆施工后盡量在一周后拋光墻面烟馅，否則很容易造成內墻膩子粉化说庭。

　　Before the construction of the project, it is necessary to ensure that the rural grass-roots level is dry, firm and free of loose materials such as oil pollution. For example, the old powder, caulking mortar and paper reinforcement powder approved by the original rural grass-roots level must be cleaned completely; the time interval between two scraps shall be identified before one scraping, and one scraping shall be conducted after one scraping; the reasons for clean and tidy cleaning behind the old wall, horizontal porosity and looseness of the rural foundation shall be solved by clear and loose position, and one brush structure integration agent, with more porosity It is to select putty powder to scrape thin batch and add filling porosity treatment. If foam is caused after drying, the soil will be scraped thick again after the foam. In addition, the humidity of the wall environment is too high, and the putty is easy to generate bubbles. The consistency of putty powder mortar is too low, and the batch scraping is also easy to generate bubbles and shrinkage. Please pay attention to the adjustment of viscosity when the painter mixes the putty powder. After the construction of emulsion paint, polish the wall as much as possible one week later, otherwise it is easy to cause the internal wall putty to be powdered.

　　以上是濟南膩子粉廠家為大家介紹的相關內容，想要了解更多內容焙糟，歡迎訪問網站：http://m.bjtsdc.comThe above is the relevant content introduced by Jinan putty powder manufacturer. To learn more, please visit the website: http://m.bjtsdc.com